How do I test my Kohler charging system?

Place a small load on the battery by turning the key to the ON position for 15 seconds. Turn the voltmeter on and turn the dial to 20 ohms. Place the black lead from the voltmeter on the negative battery post and the red lead on the positive post. The voltage should read 12 volts without the engine running.

How do you test a stator on an alternator?

To test the stator windings, with the ohmmeter on the lowest settings, test between each of the eyelets. There should be very low resistance. Test between the eyelets and the stator frame and there should be no connection.

How do I know if my stator or rectifier is bad?

Key Signs to Look For You won’t have any trouble diagnosing the faulty regulator rectifier if the battery is the cause. You’ll note signs right away like poor starts, fluctuating meter readings, and dimmed headlights. around 13 volts, the bike will start to drain the battery.

How do you test a voltage regulator on a lawn mower?

How to test a voltage regulator on a lawn mower

Step 1: Prepare your mower. Move your lawn mower onto a level, hard ground.
Step 2: Locate the voltage regulator in the mower.
Step 3: Safety preparations.
Step 4: Set the multimeter.
Step 5: test for battery voltage.
Step 6: test for regulator voltage.
No reading.
Jumpy voltage.

How do you test a stator?

Testing Your Stator So, here is how to test your stator: First, disconnect the stator connector on the left side of the bike. There are three wires. With an AC voltmeter, measure the voltage across each combination of the three wires (pins 1-2, 2-3, and 3-1).

How do you test a Kohler voltage regulator?

What does a Kohler voltage regulator do?

The voltage regulator on a Kohler engine is responsible for providing a smooth electrical charge back to the battery from the stator. When the regulator malfunctions, it can either drain the battery or cause an overcharging that can damage the battery or the wiring harness.