Is it easy to fit a new mixer tap?

Is it easy to fit a new mixer tap?

Replacing a kitchen tap is a fairly simple job to complete – you just need to have patience, a manual, and the right tools. Make sure you are extra careful when tightening, well, anything – over-tightening a single nut can lead to damage.

Can I install my own taps?

This is a job you can do yourself, but just how do you fit new taps? This is one of those tasks which shouldn’t be too difficult or too expensive. Fitting new bathroom taps should be a straightforward enough project to take on yourself, so long as you use common sense and follow simple instructions.

Are all mixer tap fittings the same?

Not all taps and countertop basins will be the same size, so you’ll want to make sure that there is adequate space from the top of your countertop basin to where the spout exits on the tap.

How to fit a tap on a basin mixer?

Here’s how to fit a basin mixer tap 1 If you need to remove an old tap, undo the connection (you may need a spanner and grips to do this) and remove the hexagonal nut holding the 2 Screw the flexible tap tails into the tap body and tighten by hand. 3 Screw fixing studs into the bottom of the tap.

How do you install a kitchen sink mixer?

3 – Pass the hoses through the hole in the sink for the mixer. 4 – Place the mixer so that the water-tight seal is in contact with the sink, . Hold the mixer in this position. 5 – Hint: use the hoses to hold the mixer firmly until it is attached.

Can you put a washer under a mixer tap?

On some models of mixer tap there is only one threaded bar making the job a great deal easier. With the washer in place the nuts can now be tightened onto the threaded bar and this is where the DIY enthusiast struggles. There is hardly any room under the basin, less under a bath and a kitchen sink is a nightmare!

How does a mixer tap mix hot and cold water?

A mixer tap is a tap that mixes hot and cold water in the body of the tap, either by using separate hot and cold levers, or a single lever that swivels from left to right to determine the flow of the hot and cold water.