How do you connect speaker wire to a phono plug?

How do you connect speaker wire to a phono plug?

Drop the outer sleeve of the RCA plug over the wire. Hold one wire to the center pin connector, heat them with the soldering iron, and then apply a small bead of solder. Repeat with the second wire and the ring connector. Then, slide the outer sleeve up over the innards of the connector and snap or screw it into place.

Can you put RCA jacks on speaker wire?

When connecting speaker wires to RCA Plugs, remove the cover from one of your RCA plugs and insert the speaker wire inside. Connect the positive wire to the plug coming from the rear. Do this by soldering them together. Once you have completed your RCA plug project, you can now enjoy high-quality music via RCA cables.

Is RCA cable the same as speaker wire?

An RCA cable is also used to connect a subwoofer or LFE (Low Frequency Effects) output to the subwoofer. Speaker wire, on the other hand, is used solely for hooking up the speakers. Speaker wire also can be used to connect to a passive subwoofer, which is not able to amplify the signal from a line level RCA input.

How do I connect speaker wire to RCA jack?

Unscrew the shells of your RCA connectors from the plugs, and slide the shells over the wire. Solder the positive lead of the speaker wire to the center pin of your RCA, and the negative to the outer lead. Allow the solder to cool, then slide the shell over the solder joints and screw tight onto the RCA jack.

How big of a cable do I need for a phono plug?

Choose screened audio cable, and note that phono plugs cannot usually accommodate thick audio cables of more than 4mm outside diameter without butchering the strain relief of the cable shell.

What kind of connector do I need for my speakers?

Also called banana plug/ jack/ socket or 4mm connector. Banana connectors are used to create connectors on bare speaker wires. Typically, you’ll find two types of terminals on your speakers – The first is a clip type where you slide the bare wire directly into the clip.

Is the RCA jack also called the phono plug?

The RCA jack or phono connector is widespread despite its poor design, this article describes how to solder it and the color codes for common signal types. The RCA Jack is also known as phono plug or sometimes cinch connector.

How to wire a phono plug and common color codes?

The amount of outer jacket that has to be removed can be measured, allowing for about 5mm of the inner conductor to go into the pin. The outer jacket should be gripped by the claw, so the shield braid needs to be twisted together to form a pigtail which can be formed around the outside of the ground connector with a pair of needle-nosed pliers.